Register/Deregister Handsets; Register A Handset; Deregister All Handsets - Clarity C1 User Manual

REGISTER/DEREGISTER HANDSETS

Your telephone can support up to five cordless handsets - C1HS™. The
handset needs to register with the telephone base before use. You must
register each handset separately.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
order they are registered (HANDSET 2 to HANDSET 5).
When first purchased, all expansion handsets alternately display
• Press FIND on base 4 sec
and
• Then press # on handset.
The new handset should be charged without interruption for at least 30
minutes before registering to the telephone base.

Register a handset

1. In idle mode, press <MENU/SELECT>, then <UP/DOWN> to select
Registration.
2. Press <MENU/SELECT> and screen will alternately show
• Press FIND on base 4 sec
and
• Then press # on handset
3. Press and hold <FIND> on the telephone base for about four seconds,
until you hear a beep.
.
4. Press # (pound key) on the handset. The screen shows Registering...
Please wait.
NOTE: NO LED indication and Alert Tone to indicate the base
is under registration mode.
When the handset is registered successfully, HANDSET registered
and then HANDSET X appears on the screen, with X being the handset
number (1-5).
40
REGISTER/DEREGISTER HANDSETS
If the registration is not successful, the handset screen shows Registration
failed. Please start again from step 1 above.
Note: You cannot register a handset if any other system handset is in use. To
register an expansion handset, follow from the step 3 as above.

Deregister all handsets

You can deregister handsets. You may need to deregister your handsets if:
You have five registered handsets and need to replace a handset.
-OR-
You wish to change the designated handset number of your registered
handsets.
You must first deregister ALL the handsets, and then register each handset you
wish to use again, one at a time.
1. Press and hold FIND on the telephone base for about 24 seconds;
release FIND.
2. Immediately press FIND again.
3. When complete, the handset screen alternately shows
• Press FIND on base 4 sec
and
• Then press # on handset.
4. To register the handset(s) to the telephone base again, follow the
registration instructions in section Register a handset.
NOTE: There are no visual or audible alerts to indicate the
base is under registration mode.
Note:
If the deregistration process is not successful, you might need to
•
reset the system and try again. To reset, unplug the power from the
telephone base and plug it back in.
You cannot deregister the handset(s) if any system handset is in use.
•
41