Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Siemens ET6..TE Series Instruction Manual

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of models and their dimensions is given on pages
2 and 3.

The control panel

&RQWURO IRU
KHDW VHWWLQJ DGMXVWPHQW
Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Extended cooking zone
æ
Halogen hotplate
<
Halogen hotplate and
<
setting
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the
#
indicator above the main switch lights up. The hob is ready for
use.
6
&RQWUROV IRU
– H[WHQGHG FRRNLQJ ]RQH
# FKLOGSURRI ORFN
PDLQ VZLWFK
&RQWUROV IRU
Activating and deactivating
Touch the
Touch the
Note: do not look into the halogen light as the glare may dazzle the eyes
(boost), with power Select power setting 9, touch the + symbol again.
›
symbol. A signal sounds. The
'LVSOD\V IRU
KHDW VHWWLQJ³É
UHVLGXDO KHDW ‡¤
RSHUDWLQJ UHDGLQHVV 
&RQWUROV IRU
 WLPHU DFWLYDWLRQ Í GXDOFLUFXLW KRWSODWH
 DQG  WLPHU DGMXVWPHQW
Notes
The settings will remain unchanged if you touch several
■
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
ð symbol
symbol
æ
If • appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to . The display remains lit until the hotplate has
œ
cooled sufficiently.
To switch off: touch the
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.
©
&RQWUROV IRU
© HOHFWURQLF ERLO
VWDUW FRQWURO
lights up in the display
›
symbol until the display above the
#