Getting started
First find a location for your new HD Radio component tuner.
1. Plug the AC power cord into the socket located on the rear,
ensuring that the plug is pushed fully into the socket.
Plug the other end of the AC power cord into a wall socket and
switch on the wall socket if needed.
2. Connect the FM Dipole into FM antenna terminal.
Setting the clock
Clock setting can be done when the tuner is in Standby ( power off )
1. Press and hold INFO button for approx. 2 seconds until display
flashes "clock set " to enter Clock Set mode.
2. Press Tuning UP or Down button to select AM or PM.
3. Press number keys to set required clock time.
4. Press INFO button again to complete clock time set.
e.g. to set 9.45 AM
a. press INFO to enter clock set mode.
b. press Tuning UP to get AM.
c. Press 0,9,4,5.
d. Press INFO again to complete clock time set.
Display will appear ERROR if the input is incorrect.
11
20060929_HDT-1_381QA0S-A_GB.p65
3. Connect the AM loop antenna into AM antenna terminal.
4. Connect the LINE OUT socket of tuner and LINE IN socket
of the AV system with supplied RCA type audio cable.
Make sure channels ( R and L ) are correctly connected.
Important:
The AM loop antenna should be located at least 50 cm away
from the tuner to avoid possible interference.
2006/10/19, ¤U¤È 02:46
8