User Maintenance Instructions; Agitator - GE WA8600SCL Use And Care Manual

PROBLEM
WATER LEAKS
WASHER IS NOISY
I
WASHER PAUSES
IN CYCLE
If you need
more help...call, toll free: GE Answer Center

USER MAINTENANCE INSTRUCTIONS

The Tub. The porcelain is self-cleaning. Leave lid
open after washing to allow moisture to evaporate.
Do not use harsh or gritty cleansers.
The Exterior. Wipe oft any spills of washing
compounds. Wipe or dust with damp cloth. Try
not to hit surface with sharp objects.
How to remove the agitator
To remove the agitator,
snap
remove the screw. Then remove the agitator extender
down onto the shaft so that it fits snugly into place.
Replace the agitator extender, the screw and the cap.
sure hose connections are tight at faucets.
Make
Make sure washer is level and firm to the floor with rubber footpads in place and
front jam nuts tight. See your Installation Instructions.
stops and the spin brake inside the transmission "locks in." This sound is normal.
Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary), the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, stop the washer by pushing in the Cycle Selector knob, open the lid and
redistribute the load evenly about the wash basket. Close the lid and restart.
Washer normally pauses between washing steps... such as between wash and spin or
between s~in and rinse.
the cap off and
straight
@
/ 800.626.2000/ consumer information service
To Store Washer. Ask service technician to remove
water from drain pump and hoses to prevent freezing.
Do
not store the washer where it will be exposed
to the weather.
Be
For Long Vacations. sure water supply is shut off
at faucets and drain all water from hoses if weather
will be below freezing.
Cap
A _
— Screw
—

Agitator

Extender
Agitator
(Appearance may vary)
- -
I
1
1
19