Preparing To Install Your Washer; Location Of Your Washer - GE SH208 Owner's Manual

Preparing to install your washer.

Before you begin–Read these instructions completely and carefully.
IMPORTANT–OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note–This appliance must be properly grounded, and electrical service to the washer must conform with local codes and
ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70 or in Canada, CSA C22.1 Canadian
Electrical Code Part 1.

Location of Your Washer

Do Not Install the Washer:
In an area exposed to dripping water or
1
outside weather conditions. The ambient
temperature should never be below 60°F
(15.6°C) for proper washer operation.
2 In an area where it will come in contact with
curtains or drapes.
In an area (garage-type building) where
3
gasoline or other flammables are kept or
stored (including automobiles).
On carpet. The floor MUST be solid with a
4
maximum slope of 1/2 per foot (1.27 cm
per 30.5 cm). To make sure the washer does
not vibrate or move, you may have to
reinforce the floor.
Undercounter Installation
If an undercounter* installation is desired, you
MUST install a top sheet kit, 14-A037. This kit is
available from an authorized parts distributor.
*Custom-sized countertop is required.
Tools Required for Washer Installation
1/4 nut driver
3/8 socket with ratchet
3/8 open-end wrench
7/16 socket with ratchet
9/16 open-end wrench
Channel-lock adjustable pliers
Carpenter's level
IMPORTANT :
Minimum Installation Clearances
When installed in alcove: Sides, Rear,
Top = 0 (0 cm)
When installed in closet: Sides, Rear,
Top = 0 (0 cm), Front = 1 (2.54 cm)
Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm
3 (7.6 cm) from top and bottom of door
Mobile Home Installation
Installation must conform to Standard for Mobile
Homes, ANSI A119.1 and National Mobile Home
Construction and Safety Standards Act of 1974
(PL93-383).
2
), located
11