Rule Configuration With The User-Defined Service; Figure 52 Bandwidth Management Rule Configuration: User-Defined Service; Table 48 Bandwidth Management Rule Configuration: User-Defined Service - ZyXEL Communications P-335 Plus User Manual

12.9.2 Rule Configuration with the User-defined Service

In addition to the pre-defined services, if you want to edit a bandwidth management rule for
other applications and/or subnets, click the Edit icon in the User-defined Service table of the
Advanced screen. The following screen displays.

Figure 52 Bandwidth Management Rule Configuration: User-defined Service

The following table describes the labels in this screen.

Table 48 Bandwidth Management Rule Configuration: User-defined Service

LABEL
BW Budget
Destination
Address
Destination
Subnet Netmask
Destination Port
Source Address
Source Subnet
Netmask
Source Port
Protocol
OK
Cancel
Chapter 12 Bandwidth Management
DESCRIPTION
Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum
or minimum bandwidth allowed for the rule in kilobits per second.
Enter the destination IP address in dotted decimal notation.
Enter the destination subnet mask. This field is N/A if you do not specify a
Destination Address. Refer to the appendices for more information on IP
subnetting.
Enter the port number of the destination. See
common services and port numbers.
Enter the source IP address in dotted decimal notation.
Enter the destination subnet mask. This field is N/A if you do not specify a Source
Address. Refer to the appendices for more information on IP subnetting.
Enter the port number of the source. See
services and port numbers.
Select the protocol (TCP or UDP) or select User defined and enter the protocol
(service type) number.
Click OK to save your customized settings.
Click Cancel to exit this screen without saving.
P-335 Plus User's Guide
Table 43 on page 108
Table 43 on page 108 for some common
for some
115