Rapid Spanning Tree Protocol Status - ZyXEL Communications MES3500-24F User Manual

Layer 2 management switch
Table of Contents

Advertisement

Chapter 13 Spanning Tree Protocol
Table 28 Advanced Application > Spanning Tree Protocol > RSTP (continued)
LABEL
Path Cost
Apply
Cancel

13.5 Rapid Spanning Tree Protocol Status

Click Advanced Application > Spanning Tree Protocol in the navigation panel to display the
status screen as shown next. See
Note: This screen is only available after you activate RSTP on the Switch.
Figure 60 Advanced Application > Spanning Tree Protocol > Status: RSTP
The following table describes the labels in this screen.
Table 29 Advanced Application > Spanning Tree Protocol > Status: RSTP
LABEL
Configuration
Bridge
Bridge ID
Hello Time
(second)
Max Age (second)
130
DESCRIPTION
Path cost is the cost of transmitting a frame on to a LAN through that port. It is
recommended to assign this value according to the speed of the bridge. The slower the
media, the higher the cost - see
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 13.1 on page 122
DESCRIPTION
Click Configuration to specify which STP mode you want to activate. Click
RSTP to edit RSTP settings on the Switch.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is
this Switch. This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of the bridge priority plus
the MAC address. This ID is the same for Root and Our Bridge if the Switch is
the root switch.
This is the time interval (in seconds) at which the root switch transmits a
configuration message. The root bridge determines Hello Time, Max Age and
Forwarding Delay.
This is the maximum time (in seconds) a switch can wait without receiving a
configuration message before attempting to reconfigure.
Table 25 on page 122
for more information.
for more information on RSTP.
MES3500-24/24F User's Guide

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mes3500-24

Table of Contents