Volvo S60 Owner's Manual page 269

Volvo s60 ower's manual
Hide thumbs Also See for S60:
Table of Contents

Advertisement

Activate/deactivate in FM mode under
FM menu
Advanced settings
Alternative
frequency.
Regional radio programmes – REG
This function causes the radio to continue
with a regional transmitter even if its signal
REG
strength is low. The symbol
the function is active.
Activate/deactivate in FM mode under
FM menu
Advanced settings
Resetting RDS functions
All radio settings can be reset to the original
factory settings.
The reset is carried out in FM mode under
FM menu
Advanced settings
Reset all FM
settings.
Volume control, programme types
The interrupting programme types, e.g.
NEWS
or
TP
, are heard at the volume
selected for each respective programme
type. If the volume level is adjusted during the
programme interruption, the new level is
saved until the next programme interruption.
Scan wavelength
The function automatically searches for avail-
able channels and takes into account any
programme type filtering. When a station is
found, it is played for approx. 10 seconds
before scanning is resumed. When a station
is playing back it can be saved as a preset in
the usual way, see the section Preset, page
264.
To start scanning go in FM/AM mode to
FM menu
shows that
NOTE
Scanning stops if a station is saved.
REG.
Radio system - DAB*
General
DAB (Digital Audio Broadcasting) is a digital
broadcasting system for radio. This system
supports DAB, DAB+ and DMB.
NOTE
Coverage for DAB is not available in all
locations. If there is no coverage then the
No reception
message
display screen.
Scan
or
AM menu
Scan.
is shown in the
*
Option/accessory, for more information, see Introduction.
06 Infotainment system
Service and Ensemble
Service - Channel, radio channel (only
audio services are supported by the sys-
tem).
Ensemble - A collection of radio chan-
nels on the same frequency.
Storing channel groups (Ensemble
learn)
When the vehicle is moved to a new broad-
casting area, programming of existing chan-
nel groups in the area may be necessary.
Programming of channel groups creates an
updated list of all available channel groups.
The list is not updated automatically.
Programming is carried out in the menu sys-
tem in DAB mode under
DAB menu
Ensemble
learn. Programming can also take
place as follows:
1. Turn TUNE one step in either direction.
>
Ensemble learn
is shown in the list of
available channel groups.
2. Press OK/MENU.
> New programming is started.
Programming can be cancelled with EXIT.
Radio
06
267

Advertisement

Table of Contents
loading

Table of Contents