More Button Functions; Remote-Pager Learn Routine; Auto Start Function; Reservation Mode - CompuSTAR 2WAMR User Manual

More Button Functions

(1) Time Setting
Button PressedFor
STEP 1 (I I +III ) - 2 sec
( I )
STEP 2 1/2 sec
( I )
1/2 sec
STEP 3
( I I )
1/2 sec
STEP 4 2 sec
(I I +III ) -
(2) RPS & Vibration mode on or off
Button PressedFor
STEP 1 (II+III ) -
2 sec
1/2 sec
( I I I )
STEP 2
1/2 sec
( I V )
Note :
Step 2 must be completed within 15 seconds. If not, start over at step 1.
Page 8
Function
Tones will sound for confirmation
Time setting is on. The numbers will
flash, and tones will sound.
Change hour.
Change minutes.
Time setting is off. Tones will
sound.
Function
Tones will sound for confirmation
RPS on or off, tones will sound for
confirmation.
Vibration mode on or off, tones will
sound for confirmation.

Remote-Pager Learn Routine

The Compustar system will allow up to three remotes to be programmed to one
vehicle. Please perform the following procedure to add or reprogram additional
remotes.
Step1 :
Activate Valet/Programming mode by manually turning the ignition
on and off five times (between Acc and On)
with the key within a 7 second period.
The parking light will flash once with successful
completion of this step.
Within a 7 second period after cycling the ignition for the 5 t h time,
Step2 :
press button I. The parking lights will flash once to confirm that
the transmitter has been programmed. You can continue
programming additional remotes. The parking lights will flash two
times when the programming mode has expired.
Auto-Start Function
Press button II for 2 seconds to auto-start an automatic transmission engine.
Remember, that a key in the ignition is required to drive the car.
For manual transmission vehicles, please use reservation mode.
Press button I I for 2 seconds in order to turn off an auto-started car.
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset
options at the time of installation and then shut off.
shows the amount of run-time left in the remote
-
start mode.
A n t i - G r i n d
The anti-grind circuit (an optional feature provided by your installer) prevents you
from engaging the starter on a remote-started vehicle.
Page 9