Problem Solver - GE Monogram ZV1050 Owner's Manual

Questions? PROBLEM
Use this
FAN DOES NOT
OPERATE WHEN
problem
THE SWITCH IS ON
solver!
FAN FAILS TO
CIRCULATE AIR
FAN OPERATES BUT
MOVES AIR SLOWER
THAN NORMAL
FAN KEEPS GOING
OFF AND ON
CLEAN FILTER LIGHT • The filters have been in place for 30 hours of "on" time. Remove the
IS ON OR BLINKING
8
POSSIBLE CAUSE
• A fuse may be blown or a circuit breaker tripped. Replace fuse or
reset circuit breaker.
• Fan blade striking the hood shell.
• Excessively soiled filter should be checked and corrected before
using the hood again.
• Check to be sure the filter is clean. If replacing the filter does not
correct the problem, call for service.
• The motor is probably overheating and turning itself off. This can
be harmful to the motor. Check to be sure the filter is clean. If off
and on cycling continues, call for service.
filters, clean if necessary and replace them. Make sure they are
correctly seated in the filter channels. Adjust as necessary until the
red signal light stops blinking. See the Metal grease filter/
Clean filter light section.
The Problem Solver
Stainless Steel Hood