HOW TO INSTALL
1. Identify the wall-sleeve brand you have from the chart below:
Brand
White-Westinghouse
Frigidaire/Sunbeam
Carrier (52F series)
General Electric/Hotpoint
Whirlpool
Fedders/Emerson
Sears/Kenmore
Emerson/Fedders
Carrier (51S series)
Friedrich
Notes:
•
All wall sleeves used to mount the new air conditioner must be in sound structural condition and
have a rear grille that securely attached to the sleeve or rear fl ange that serves as a stop for the air
conditioner.
•
When the installation is complete, the replacement unit must have a rearward slope as shown.
2. Remove the old air conditioner from the wall sleeve and prepare wall sleeve as follows:
•
Clean interior
•
Wall sleeve must be securely fastened in the wall before installing your new air conditioner.
Drive more nails or screws through the sleeve and into the wall if necessary.
•
Repair paint if needed.
Wall Sleeve Dimensions ( HxWxD)
15 1/4" x 25 1/2" x 16, 17.5, or 22"
15 1/4" x 25 1/2" x 16, 17.5, or 22"
15 1/4" x 25 1/2" x 16, 17.5, or 22"
15 5/8" x 26" x 16 7/8"
16 1/2" x 25 7/8" x 17 1/8 or 23"
16 3/4" x 27" x 16 3/4 or 19 3/4"
16 7/8" x 25 3/4 x 18 5/8"
15 3/4" x 26 3/4" x 15"
16 7/8" x 25 3/4" x 18 5/8"
16 3/4" x 27" x 16 3/4"
3