Wall Sleeve Brand: Fedders, Friedrich (16 3/4" Deep); Trim Kit Assembly - Sunbeam Air Conditioner Installation Instructions Manual

WALL SLEEVE BRAND: Fedders, Friedrich
1. Redirect the louvers at the back of the wall sleeve.
2. Attach the (2) 4 1/2" x 3 1/2" x 1 1/2" centering/support
blocks, one on each side wall. Place in the center of the side
wall with the tapered end facing the sleeve opening.
3. Cut (2) 17" tapered spacer blocks into two pieces, 2 1/2" and
12 1/2" each.
4. Place the 2 1/2" section in front of the rib on the base, with
the tapered end facing the back of the sleeve. The remaining
portion should be placed behind the rib again, sloping toward
the rear of the unit.
5. Attach (1) 1 1/2" x 3/8" x 25" seal in the center at the top of
the sleeve. Remove the backing paper and press into position.
6. Attach (2) 1 1/2" x 3/8" x 25" seals to the left and right sides
of the sleeve.
7. Cut the 1 1/2 x 3/8" x 25" seal to 14" and attach it to the
vertical section of the rear grille.
8. Gently slide the air conditioner into the sleeve.
9. Before sliding the unit all the way in, remove the second screw and washer from the front-left side of
the unit.
10. Screw and attach the other end of the ground wire to the unit, making sure the toothed washer is
against the cabinet.
11. Install the 1" x 1 1/2" x 84" stuffer seal between the wall sleeve and the air conditioner.
12. Assemble and install the trim frame (see "Trim Frame Assembly" section of manual).
TRIM FRAME ASSEMBLY
The purpose of the trim frame is to cover space between the wall sleeve and the replacement air
conditioner cabinet. Each frame is made of four parts.
1. To assemble the trim frame, insert the snaps of the side legs into the top and bottom legs.
2. To install the trim frame to the sleeves, slide the frame over the cabinet until it is fl ush with the wall
sleeve.
• Note: Be sure to route the cord through the trim frame before placing the trim frame on the unit.
(16 3/4" deep)
11