Casablanca MISSION Owner's Manual page 6

Step 5. To hang the fan body in the canopy, hold the fan
body fi rmly and insert the nylon ball into the canopy open-
ing. Rotate fan body until slot on nylon ball fi ts into pin
opposite canopy opening.
NOTE: The fan weight is 36 pounds.
CANOPY ELECTRICAL CONNECTIONS
Step 6. Connect the fan wires to the outlet box
wiring by placing the bare ends of the wires
together and then securing with a wire nut.
Connect in this order:
• GREEN leads from mounting plate and fan to
GROUND conductor of power source. Secure
with wire nut.
• WHITE wire from fan to white NEUTRAL wire
in ceiling fi xture outlet box.
Secure with wire nut.
• BLACK wire from fan to black POWER wire
in ceiling fi xture outlet box.
Secure with wire nut.
Inspect each wire nut and ensure that no bare
wire is visible; pull on each wire to test the
connection is mechanically sound.
Step 7. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 8. Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening.
Tighten the screws fi rmly by hand only,
Step 9. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.
6
HANGING THE FAN
CANOPY HATCH INSTALLATION
Note: Write down the
Serial Number and the
model number for future
reference.
BALL
SLOT
2 BLACK WIRES
2 WHITE WIRES
3 GREEN WIRES
WIRE NUT
CANOPY
HATCH
LOCK
WASHER
CANOPY
SCREW
CANOPY
PIN
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW