Resilient Mode - McAfee MAP-3300-SWG - Web Security Appliance 3300 Product Manual

Table 230 Option definitions (continued)
Option Definition
Add a new address, or remove a selected IP address.
New Address/
Delete Selected
Address
NIC 1 Adapter Expand to set the following options:
Options or NIC 2
• MTU size — specifies the Maximum Transmission Unit (MTU) size. The MTU is the
Adapter Options
maximum size (expressed in bytes) of a single unit of data (for example, an
Ethernet Frame) that can be sent over the connection. The default value is 1500 bytes.
• Autonegotiation state — either:
• On — allows the appliance to negotiate the speed and duplex state for
communicating with other network devices.
• Off — allows you to select the speed and duplex state.
• Connection speed — provides a range of speeds. Default value is 100MB.
• Duplex state — provides duplex states. Default value is Full duplex.
• Enable IPv6 auto-configuration — Select this option to allow the appliance automatically
configure its IPv6 addresses and IPv6 default next-hop router, by receiving Router
Advertisement messages sent from your IPv6 router.
This option is unavailable by default if your appliance is running in transparent router
mode, or is part of a cluster configuration, or running as part of a Blade Server
installation.

Resilient Mode

Use this page of the user interface to enable resiliency mode on your blade server.
This page only applies to the McAfee
Table 231 Option definitions
Option Definition
Within this area, you can check the current status regarding resiliency of your
Enable Resilient
blade server.
Mode
You can also enable or disable resiliency mode.
Configuration Files From the user interface, you can view or download the interconnect configuration
files for both resilient and non-resilient mode operation for all the interconnects.
®
Content Security Blade Server.
Ensure that you have downloaded the chassis configuration files before enabling
resiliency mode.
After clicking Enable Resilient Mode or Disable Resilient Mode, and clicking OK on
the warning dialog box, your blade server will automatically be shut down,
allowing you to make the required cabling changes.
To download all the configuration files, click interconnect_config.zip, as this file
contains all the other configuration files.
McAfee Email and Web Security Appliances 5.6.0 Product Guide
Overview of System features
Cluster Management
239