Raid Enable In Bios; Select A Raid Array For Use - Foxconn M61PMP-K User Manual

5-2 RAID enable in bIoS

1. Enter the BIOS setup by pressing [DEL] key when boot up.
2. Select the "Integrated Peripherals" from the "Main menu", then select the
Config" menu and press [Enter] to go to the configuration items.
3. Enable RAID function and individual SATA port for hard drive or DVD connection.
4. Press [F10] to save the setting then PC will reboot itself.
RAID Enable
SATA Pri-Master RAID
SATA Pri-Slave RAID
SATA Sec-Master RAID
SATA Sec-Slave RAID
↑↓→←:Move Enter:Select

5-3 Select a RAID Array for Use

When BIOS is restarted, it will display a message asking you to press [F10] key to
enter the main menu of MediaShield BIOS. Press [F10], the screen appears.
At the bottom of each screen displayed, there is one line listing each key's function,
such as [Tab], [Enter], [ESC]...etc. It is helpful to make your choice easier.
RAID Mode: Mirrored
Free Disks
Port Disk Model
0.0 WDC WD1200JD-9 111.79GB
0.0 WDC WD1200JD-9 111.79GB
0.2 Hitachi HDT725
0.1 HDS728080PLA38 76.69GB
0.3 ST3320620AS
[ESC] Quit
Phoenix - AwardBIOS CMOS Setup Utility
RAID Config
[ IDE]
Enabled
[Disabled]
[Disabled]
[Disabled]
[Disabled]
+/-/PU/PD:Value
F5: Previous Values
MediaShield BIOS Jul 27 2007
- Define a New Array -
Mirrored
Capacity
232.88GB
[+] Add
298.09GB
[-] Del
[F6] Back [F7] Finish [TAB] Navigate
Item Help
Menu Level ►
F10:Save ESC:Exit F1:General Help
F7: Optimized Defaults
Optimal
Stripe Block: Optimal
Array Disks
Port Disk Model
[↑↓] Select
71
"RAID
Capacity
[Enter] Popup