REPLACING THE POWER SUPPLY CABLE
Important! This appliance must be connected to the electricity supply only by an
authorised person.
To connect the supply cable:
■
Unhook the terminal board cover by inserting a screwdriver into the two hooks "A" (fig. 5).
■
Open the cable gland by unscrewing screw "F" (fig. 6), unscrew the terminal screws
and remove the cable.
■
The new supply cable, of suitable type and section, is connected to the terminal board
following the diagram fig. 7.
■
Close and hook again the terminal board cover.
N.B. The earth conductor must be left about 3 cm longer than the others.
VOLTAGE AND POWER CONSUMPTION
220-240 V ac
FEEDER CABLE SECTION
TYPE H05RR-F
3 x 1,5 mm
(*) (**)
2
(*) Connection possible with plug and outlet
(**) Connection with wall box connection.
Figure 6
2350 W (10.21 A)
F
Figure 5
A
Figure 7
220 - 240 V
L
N (L
1
E
)
2
11