Steaming Tips - Conair Extreme STEAM GS23C Instruction Booklet

OPERATING
INSTRUCTIONS
1. Plug the unit into the electrical outlet.
2. The power light will light up (red). Allow
one or two minutes for the unit to warm up.
The appliance is ready to use when the ready
light goes on (green).
3. Holding the steam jets away from you
and anyone else in the room, engage the
trigger. Steam should now be released from
the steam jets. To have continuous steam,
just move switch down so you will have
continuous steam without having to hold the
trigger. Always have steam facing away
from you or anyone in the room.
4. When first using the device, test on an old
cloth, as there may be sediment left from the
manufacturing process or transportation.
5. On the back of the steamer there is a
sliding switch for high and low settings. High
is for heavier and badly wrinkled fabric and
provides faster, hotter, less visible steam.
Low setting should be used for delicate fabrics
like silk, in combination with soft cushion brush
attachment.
6. To stop the flow of steam, release the
trigger or lower the switch.
7. Unplug the device when it is not in use.

STEAMING TIPS

1. To prepare your fabric for steaming, brush
it with the soft cushion brush attachment. This
will loosen the fibers and allow better steam
penetration.
2. Hang your garment or fabric.
3. Pass the steam jets just above the fabric
where the wrinkles are. It may take a few
passes to remove the wrinkles completely.
4. After use, unplug steamer and empty any
remaining water from the tank to avoid leakage.
5. CAUTION: When hanging garment on
a door while steaming, be careful not to
damage the door with steam.