Conair CGS30K - Garment Steamer Manual

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER

SAFETY PRECAUTIONS

• 
  The polyethylene bags over the product or its packaging may be dangerous. Keep these bags out of the reach of babies and children.
  
  Never use them in cribs, children's beds, pushchairs or playpens. The thin film may cling to the nose and mouth and prevent breathing. A bag is not a toy.
• 
  Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
  

1. If you are using the unit in a bathroom, unplug it after you have finished using it. Using the unit close to a source of water can, in fact, be dangerous, even if the unit is switched off. To ensure additional protection, have installed in your bathroom a residual current device (RCD) with a nominal trip current no higher than 30 mA. Ask your electrical fitter for advice.
2. Never immerse the unit in water or any other liquid.
3. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
4. Do not use the unit if it has fallen or if it appears to be damaged.
5. Do not leave the unit unattended when it is plugged in or switched on.
6. Unplug the unit immediately if you have problems when using it.
7. Do not use any accessories other than those recommended by manufacturer.
8. Unplug the unit after each use and before filling or cleaning.
9. This unit is not intended for use by people (including children) with reduced physical, sensory or mental capabilities, or by persons who lack experience or knowledge, unless they are supervised or have been given instructions beforehand on the use of the unit by a person responsible for their safety. Children should be supervised to make sure they do not treat the unit like a toy.
10. Allow the unit to cool before storing.
11. To prevent damage to the cord, do not wrap it around the unit and ensure it is stored without twisting or folding it.
12. When emitting steam, this appliance may cause burns if it is used too close to the skin or eyes, or if it is used incorrectly. To reduce the risk of contact with hot water emitting from the steam vents, test appliance before use by holding it away from the body.
13. Do not steam garments while on a person.
14. Always keep the hose and nozzle elevated above the water container.
15. Burns could occur from touching hot metal parts, hot water or steam. Use care when you turn steam appliance upside down.
16. Do not operate steamer without correctly filling the water container. Only use clean cold water for filling this appliance. In hard water areas, we recommend the use of distilled water.
17. Use of an extension cord is not recommended. If an extension cord is absolutely necessary, a 13-ampere-rated cord should be used. Cord rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
18. Use with caution when carrying steamer as it contains hot water.

NOTE: Before using the garment steamer for the first time, it is recommended to operate the steamer for approximately 5 minutes, unplug the unit and allow it to cool. Empty container and refill before actually using.

STEAMER ASSEMBLY

HOUSEHOLD USE
STEP 1 – Assembling the Support Rod(household use only)

1. Insert pole with bigger diameter side into receptacle in base (Fig. a)
   
2. Slide plastic connector onto it and fix the connector tightly (Fig. b)
   
3. Open the locking tab and pull out the telescope pole totally (Fig. c)
   
4. Lock up the tab (Fig. d)
   
5. Slide hook into the top of the pole (Fig. e)
   

STEP 2 – Attaching the steamer Hose
Assembly process:

1. Align to unlock arrow
   
2. Press
   
3. Turn clockwise till align to lock arrow
   

Removing the Steamer Hose (make sure unit has been cooled)
Disassembly process:

1. Turn counterclockwise till align to unlock arrow
   
2. Pull
   

OPERATING INSTRUCTIONS

BEFORE FILLING THE WATER CONTAINER

Turn the water container upside down and inspect to make sure the valve and spring assembly are functioning. Place the container in the reservoir and check that it is seated securely. If the container has been stored with water inside, it may be necessary to remove the water and clean the container. Follow the steps for care and cleaning.

FILLING THE WATER CONTAINER

(PRIOR TO PLUGGING IN THE APPLIANCE)

Remove the water container with the handle and turn upside down. Unscrew the valve in the center of the base. Fill container by holding container under a source of running cold water until the container is filled to the desired level. Do not overfill. Screw the valve cap onto the water container and return the container to the upright position. Place the water container onto the base and make certain it is seated properly in the cavity.

DO NOT FILL THE CONTAINER WITH HOT WATER.

GETTING TO KNOW YOUR STEAMER

OPERATING THE STEAMER

1. Make sure all hose connections are secure and tight.
2. Make sure the rod is fully assembled and the hose is not twisted or kinked.
3. Plug the power cord into a normal electrical outlet.
4. Turn the switch to the "I" position or "II" position for low or high steam rate.
5. The indicator will light to indicate when power is on.
6. Steam will be produced from the nozzle in about one minute.
   
   Hose will be hot when in use. Avoid prolonged contact.
7. Should the water container run out of water, the unit with automatically turn on and off, cycling the indicator lamp on and off.
8. Switch off the unit for end of use or refilling the water container for reoperation.

CLEANING AND STORING

1. Turn the switch to the "O" position and unplug from the power source.
2. Wait for the steamer to cool completely for at least 30 minutes.
3. Unplug power cord and gently wrap around built-in cord wrap for storage.
4. Remove the steamer hose.
5. Remove the water container from unit, unscrew valve and empty unused contents. Allow to air dry.
6. Remove excess water from the reservoir by lifting the unit and pouring into a sink.
7. Replace water container.
8. Store the unit.

OTHER IMPORTANT NOTES

During operation, the steamer hose may gurgle. This is a normal result of condensation collection inside the hose. Simply lift the handle upward until the hose is extended to its full height. The gurgling will stop when the excess moisture inside the hose has had a chance to drain back into the base.

CLEANING/STORING/MAINTENANCE

• After use – wait for it to cool down before cleaning and then remove any water left in water tank.
• Allow the water tank to dry thoroughly.
• Keep this garment steamer out of reach of babies and children.
• Do not wrap the power cord around the unit and ensure it is stored without twisting or folding it.
• For the best performance, limescale should be removed from time to time.

Note: Minerals in water will vary in different areas. To insure continued operation of the steamer, use only purified/distilled water, never store without cleaning and removing excess water from the reservoir and water container.

HOW TO STEAM

Grasp the steam nozzle with the steam jets facing away from you. Begin at the bottom of the fabric to allow the steam to rise inside and outside, removing wrinkles, slowly move the nozzle from the bottom to the top of the fabric. Remove the nozzle from the garment and smooth the fabric with your free hand. Some fabrics are best steamed on the underside of the material. This will allow the fibers of the fabric to relax, eliminating wrinkles.

NOTE: Test fabric for color fastness in an inconspicuous spot. Drape linens, towels, handkerchiefs and napkins over a rod or place on a towel rack, Heavier fabrics may require repeated steaming. Repeat as necessary with practice, you will gain speed and efficiency, You will soon learn which fabrics require multiple steam applications.

Do not directly touch velvet or silk with the steam head.

Always steam with hose in upright position, so any condensation is free to flow back into the steamer.

If you steam with hose not upright, condensation will collect inside the hose. This will cause gurgling and some water droplets to form near the steam jets on the handle. To avoid this, frequently lift the steam handle upward until the hose is extended to its full height.

TO STEAM DRAPES

Wash and dry drapes as directed according to fabric type. Re-hang drapes and steam drapes when in place.

TROUBLE - SHOOTING THE STEAMER

PROBLEM	CAUSE	SOLUTION
Steamer fails to heat	Steamer not plugged in	Plug into electrical outlet
No steam	Water level is low	Turn switch to "O" and refill water container
Water drips from nozzle	Condensation in hose	Hold the hose vertically and allow water to drain back into unit
Nozzle gurgles	Condensation in hose	Hold the hose vertically and allow water to drain back into unit
Poor steam performance	Sediment in container	Decalcify reservoir and water container

Note: Minerals in water will vary in different areas. To insure continued operation of the steamer, never store without cleaning and removing excess water from the reservoir and water container.

ONE YEAR LIMITED WARRANTY

This Conair Appliance is guaranteed for consumer use for one year. Please fill in and return the Warranty Registration as instructed or log into www.conair-asia. com to register. This guarantee is no longer valid in case of alteration or repair by any unauthorized persons and only covers defects under normal use from the date of purchase. If your product does not perform satisfactorily because of defects in materials or manufacture, it will be repaired or replaced under guarantee through the Conair Service Centre. Conair reserves the right to amend terms and specifications without prior notice. To obtain service under this warranty, please send in registration within one month of purchase through either one of the following ways.

THE DATE CODE MENTIONED
WWYYXXX was mentioned on unit as manufactured date so you can see W as week and Y as year for your reference.

CONAIR KOREA CUSTOMER SERVICE:
Conair Korea Trading Limited
Customer Center: 1899-0209
A/S Center: www.fillelec.co.kr