IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, especially when children are present, basic safety precautions should always be taken, including the following: READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER DANGER — Any appliance is electrically live even when the switch is off. To reduce the risk of death by electric shock: 1.
Page 4
04. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped or damaged, or dropped into water. Do not attempt to repair the appli- ance. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to per- sons when the appliance is used.
Page 5
14. Unplug this appliance before filling or emptying. Do not overfill. 15. While emitting steam, this appliance may cause burns if it is held too close to the skin, scalp or eyes, or if it is used incorrectly. To reduce the risk of contact with hot water as it escapes through steam vents, test appliance before each use by holding and testing it away from body.
GETTING TO KNOW YOUR STEAM PRESS 1. The Pressing Handle raises and lowers the Pressing Plate. 2. The Locking Knob will lock together the Pressing Plate and the Ironing Board. Use this to carry or store the Steam Press. 3. The Steam Burst Buttons on either side of the Pressing Handle produce a burst of steam when pressed.
Page 7
08. The Green Indicator Light goes off when the Pressing Plate has reached the selected temperature 09. The Yellow Steam Ready light goes on when the unit is ready to produce bursts of steam 10. The Temperature Control dial 11. The Water Tank 12.
FEATURES OF THE STEAM PRESS Your Steam Press provides clean, professional results every time! • Pressing surface is seven times larger than most hand-held irons • Can reduce ironing time up to 50% • Multiple dry and steam settings, burst setting to remove stubborn wrinkles •...
IMPORTANT For Household Use Only Filling Instructions: Do not plug the unit in until you have filled the Water Tank 1. Set the appliance on a steady work surface. 2. Unlock the Locking Knob. 3. Raise the Pressing Plate. 4. Filling the Water Tank: In areas of hardwater, use Distilled Water. Slide the Water Tank forward.(Fig.
STEAMING TIPS Pressing Garments 1. Lay the garment on the Ironing Board. 2. Lower the steam plate and return to the open position after a few seconds. NOTE: the unit will automatically turn off the heating plate after 10 seconds in the closed position. A beep will emit until the unit is opened. Once the unit is opened, it will return to normal operation.
Page 11
Shirts and Blouses 1. Place the shoulder yoke on the Ironing Board first and press. 2. Then place the sleeves on the Ironing Board with the fold parallel to the long seam and press. 3. Place the cuffs on the end of the board and press. 4.
Page 12
Pants 1. Place the Pressing Cushion under the waistband and press, repositioning the waistband until completely pressed. 2. To press the inseam, place the cushion under the area to be pressed. 3. Place the pleated area on the board. Carefully fold pleats and press. 4.
Page 13
Using the Pressing Cushion 1. For garments constructed with details such as darts, curved seams, and shoulder pads, a Pressing Cushion may be used. 2. Use the cushion in areas where no creases are desired or to shape a tailored garment. 3.
CLEANING THE STEAM PRESS 1. Place the Pressing Cushion in the middle of the Ironing Board. 2. Place a clean towel over the Pressing Cushion and the Ironing Board. 3. Set the temperature control to its highest setting. 4. When the Steam Indicator Light illuminates, lower the Pressing Plate onto the cushion.
TROUBLESHOOTING THE STEAM PRESS Before taking the unit to a service center, please check the following list of common problems for your issue. Problem Cause Solution Steam Press does not open Locking Knob is in Locked position Turn the Locking Knob to the unlocked position Steam Press Temperature setting not high...
Page 16
LIMITED ONE YEAR WARRANTY Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials. To obtain service under this warranty, return the defective product to the service centre listed below that is nearest you, together with your purchase receipt and $15.00 for postage and handling.
Need help?
Do you have a question about the FSP10C and is the answer not in the manual?
Questions and answers