Panasonic SC-NE3 Owner's Manual page 14

Software update
Occasionally, Panasonic may release updated
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
Preparation
≥ Turn the unit on.
≥ Connect this unit to the wireless network. (l 7)
– Make sure that the wireless network is
connected to the Internet.
– If "D.CONNECT" is set to "ON", change the
setting to "OFF" and connect this unit to a
wireless network that is connected to the
Internet.
1
Press [SETUP] repeatedly to select
"SW UPDATE" and then press [OK].
2
Press [3, 4] to select "UPDATE? Y" and then
press [OK] to start the update.
DO NOT DISCONNECT the AC power supply
cord while one of the following messages is
displayed.
– "LINKING", "UPDATING" or "
(" " stands for a number.)
≥ During the update process, no other operations can be
performed.
3
When the update has finished successfully,
"SUCCESS" is displayed.
4
Disconnect the AC power supply cord and
reconnect it after 3 minutes.
≥ Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
≥ If you do not want to update the unit, select "UPDATE? N"
and then press [OK] in step 2.
≥ If there are no updates, "NO NEED" is displayed after step 2.
∫ Checking the software version
1 Press [SETUP] repeatedly to select "SW VER." and then
press [OK].
{. The version of the installed software is displayed.
2 Press [OK] to exit.
14
VQT4U49
Display the name for the connected wireless
network (SSID).
1
2
≥ If "NOCONNECT" is displayed this unit is not connected to a
≥ All letters are displayed as capital letters, and characters that
To check the unit's IP address or the Wi-Fi MAC
address.
1
%"
2
≥ To exit the setting, wait 20 sec.
≥ The " – " displayed on the top or bottom left of the display
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
2
3
≥ To change the mode back to "REMOTE 1", repeat the steps
Wireless network name (SSID)
Press and hold [– WPS] on the unit and [OK]
on the remote control until the unit's display
shows the SSID.
Press [OK] to exit.
wireless network.
cannot be displayed are replaced with "
IP/MAC Address
Press and hold [– WPS] on the unit and [4] on
the remote control until the unit's display shows
the IP address.
{. The IP address is partially displayed.
≥ To display the MAC address on the unit, repeat the
steps above by replacing [4] with [3].
Press [3, 4] on the remote control to show the
rest of the IP address.
indicate the first and last units respectively.
Changing the unit and remote
control code
Press [ , AUX] to select "AUX".
While pressing and holding [
unit, press and hold [SOUND] on the remote
control until the unit's display shows
"REMOTE 2".
Press and hold [OK] and [SOUND] on the
remote control for at least 4 seconds.
above but replace the button pressed on the remote control
from [SOUND] to [ , AUX].
¢ ".
/ AUX] on the