Superio Configuration - Foxconn H55M-S User Manual

SuperIO Configuration

SuperIO Configuration
Serial Port1 Address
Serial Port2 Address
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
OnBoard CIR Port
↑↓←→:Move Enter:Select
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request(IRQ) for the onboard serial
port1.
► Serial Port2 Address
This item is used to assign the I/O address and interrupt request(IRQ) for the onboard serial
port2.
► Parallel Port Address
This item is used to assign the I/O address and interrupt request(IRQ) for the onboard parallel
port.
► Parallel Port Mode
This item is used to select the operation modes for the onboard parallel (or Printer) port. They
are [Normal] (default), [EPP], [ECP] and [ECP+EPP].
► Parallel Port IRQ
This item is used to assign interrupt request(IRQ) for the onboard parallel port.
► OnBoard CIR Port
This item enables you to determine the transfer mode of the onboard infrared chip.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
SuperIO Configuration
+/-/:Value
F9:Optimized Defaults
Help Item
[3F8/IRQ4]
Allows BIOS to Select
[2F8/IRQ3] Serial Port1 Base.
[378] Addresses
[Normal]
[IRQ7]
[Disabled]
F10:Save ESC:Exit
35
F1:General Help