Sharp MD-MT180 Service Manual page 11

How to remove the Lift motor (See Fig. 11-1.)
1. Remove the solder joints (D1) x 2 of the lift motor lead wire.
2. Remove the screw (D2) x 1 pc., and remove the lift motor.
Note:
Take care so that the motor gear is not damaged.
(If the gear is damaged, noise is caused.)
How to reinstall the optical pickup
(See Fig. 11-2.)
1. Remove the screw (E1) x 1 pc., and remove the spring.
2. Slowly raise the optical pickup.
Optical Pickup Unit
– 11 –
MD-MT180
Lift Motor
SolderJoints
(D1)x2
(D2) x1
ø1.4 x5mm
Figure 11-1
(E1) x1
ø1.7 x3.5mm
Spring
Figure 11-2