Multi-Connector Cable - Axis Q6045-C User Manual

AXIS Q6045-C PTZ Dome Network Camera

Multi-Connector Cable

Multi-Connector Cable
The supplied multi-connector cable is required in order to maintain the camera's IP rating.
Connect the multi-connector cable to the camera's multi-connector and to the connectors in the supplied media converter switch,
see page 6 .
The cable provides the following signals:
• DC power
• Network (Ethernet 10/100Base-T)
• Input/Output (I/O)
Function
Configurable (Input
or Output)
RX+
RX-
TX+
TX-
GND
12 V power
Pin – wire
2 – blue
7 – yellow
3 – green/white
4 – green
5 – orange/white
6 – orange
8 – black
1, 9 – red
Notes
Digital input – Connect to GND to activate, or
leave floating (unconnected) to deactivate.
Digital output – Internal connection to ground
when activated, floating (unconnected) when
deactivated. If used with an external relay, a diode
must be connected in parallel with the load, for
protection against voltage transients.
Ethernet – receiving
Ethernet – receiving
Ethernet – transmitting
Ethernet – transmitting
Ground
Used to power camera
58
Specifications
0 to +30 V DC
Max load =
100 mA
Max voltage =
+30 V DC
12–13.2 V DC
Max load = 6 A