Table of Contents
Advertisement
BeFore You Start... continued
(See INDEX: "Gas Requirements") Pay special attention to
the provisions shown for gas line hook-up.
The enclosure should have ventilation holes to prevent gas
build-up in the event of a leak. The deck ledges and coun-
ter should be flat and level. (refer to ANSI Z21.58 Standard
for Outdoor Cooking Gas Appliances, Section 1.7 Enclo-
sures For Self Contained LP-Gas Supply Systems)
This grill requires that a 120 volt, 60 hertz, 15 amp GFI cer-
tified outlet be installed by a qualified electrician.
CLEARANCE TO COmbUSTIbLES
Minimum clearance from the sides and back of the grill to
adjacent combustible construction below the top of unit
are 12" from the sides and back.
Dégagement minimal entre les parois latérales et l'arrière
de l'appariel et la construction combustible au-dessous du
panneau supérieur de l'appareil (30 cm à partir des parois
latérales et 30 cm à partir de l'arrière).
Minimum clearance from sides and back of unit to adjacent
combustible construction extending above the unit is 18"
from the sides and back.
Dégagement horizontal minimal entre les parois latérales
et l'arrière de l'appariel et la construction verticale combus-
tible au-dessus de l'appareil (45.7 cm à partir des parois
latérales et 45.7 cm à partir de l'arrière).
Do not use this appliance under overhead combustible
surfaces.
Ne pas utiliser cet appareil sous une surface combustible.
A minimum of 6" of clearance is needed on the left side of
the grill above the counter top for the motor and skewer.
If the grill is to be placed in a combustible enclosure an ap-
proved insulating jacket is necessary. Order model number
LIJ400, LIJ500 of LIJ600 depending on your grill size.
REAR hOOD CLEARANCE
A 3 inch clearance is required behind the grill to allow the
front hood to open.
The grill exhausts combustion products and cooking greas-
es to the back. Never locate the grill where this exhaust will
be difficult to clean.
SEDONA CARE & USE/INSTALLATION
|
23
Advertisement
Table of Contents
