Maintenance - Fujitsu Aviamo P37FT05AEB User Manual

Full hd display
Table of Contents

Advertisement

MAINTENANCE

If yoIn the event of problems with the display, check the following explanations before contacting your dealer for servicing.
Problem
• Power does not turn ON.
• No pictures are displayed.
• Remote control does not function prop-
erly.
• The display makes a snapping sound.
• The display makes a buzzing sound.
• There are spots on the screen.
• Degraded colors/tints
• Improper screen position/size
• No audio
• If "Out of range" appears, the display is
receiving a signal whose picture or signal
cannot be reproduced by the display.
• The screen turns to black and white.
• If "Error message Condition 1" appears,
the fan is defective.
• If "Error message Condition 2" appears,
the display's internal components are
extremely hot.
• If "Change refresh rate to 60Hz" appears,
• If the power indicator lamp flashes red or
green.
• Picture display, audio output and remote
control operation, etc. not performed
normally.
• Check whether the power plug is securely inserted into the receptacle.
• Check cables for disconnection.
• Check whether the power for all input equipment is ON.
• Check for connection to wrong terminals or for wrong input mode.
• Check whether the input mode display is colored pink.Special setup may have been made.
Return to original setup or initialize the User adjustment value.
• Check for incorrect battery orientation.
• Check for dead batteries.
• Check for distance from the display.
• Check whether you are pointing the remote control transmitter properly at the
display's receiver.
• Check for any obstacle between the remote control and the display.
• This sound is produced when the cabinet expands or contracts due to variations in temper-
ature. This sound does not indicate that the display has a problem.
• The display has fans to maintain the temperature of internal components at a constant
level. This sound is produced by the fan as it rotates. (Applies to models equipped with a
fan.)
• Check whether your AV equipment is affected by interference from automobiles, trains,
high-voltage transmission lines, neon signs or other potential sources of interference.
• Check whether all picture adjustments have been properly made.
(See "ADJUSTING TO A DESIRED PICTURE" on P. E-27–E-30.)
• Check whether screen position and size have been properly adjusted.
(See "ADJUSTING SCREEN POTISION AND SIZE" on P. E-33.)
• Check cables for disconnection.
• Check whether the proper audio input has been selected.
(See "Audio Input" on P. E-36.)
• Signals that are not supported by this display have been input. Check which signals are
supported. (See "MAIN SUPPORTED SIGNALS" on P. E-45.)
• Remove the power plug from the receptacle, and contact your dealer for repairs.
(Applies to models equipped with a fan.)
• Remove the power plug from the receptacle. (You can turn the power back ON again
when the components have cooled sufficiently.) If the message appears again when you
turn the power back on, remove the power plug from the receptacle, and contact your
dealer for repairs.
• The picture may get blurred with vertical frequency of other than 48.3-51.8 or 58.4-61.4
(Hz). Change the setting of your PC, etc.
• Remove the power plug from the receptacle, and inform your dealer about how the lamp
flashed.
• The power indicator lamp flashes differently depending on the type of problem.
• When display does not operate normally, pull the power plug from the receptacle, wait
approximately 1 minute, insert the power plug back into the receptacle, turn on the power,
and then check if the display operates normally.
Action
E-47

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aviamo p65ft00aeb

Table of Contents