Configuring A User Drum Set - Casio LD-50 User Manual

To select a drum set
1.
Press the DRUM SET button.
Current drum set setting
2.
Rotate the dial left or right to cycle through the available drum sets until the one you want is displayed.
3.
After you are finished, you can press another button to change to another mode.

Configuring a User Drum Set

The following procedure describes how you can configure up to two of your own drum sets that consist of the
percussion sounds and sound effects you want.
After you configure a user drum set, you can select it using the procedure under "To select a drum set" on this
page.
NOTE
• User drum sets revert to their initial factory defaults whenever your Digital Drum is turned off.
• See "Drum Set List" on page A-2 for information about the initial factory default settings of the user drum sets.
To configure a user drum set
1.
In any mode, press the ASSIGN button.
Indicates the currently selected user drum set
2.
Rotate the dial to select either User Area 1 (U1) or User Area 2 (U2), and then press the ASSIGN button.
Sound currently assigned to
the selected pad
272A-E-023A
Page 21
Flashing dial icon
Flashing dial icon
Selected pad
02.10.28, 11:19
Drum set selection screen indicator
User drum set screen indicator
E-21