Fujitsu PRIMERGY TX300 S7 Operating Manual page 17

Hard disk drives
The server is shipped with one of the following drive cages:
– For up to eight 3.5-inch SAS/SATA HDD:
Up to eight SAS/SATA HDD modules can be used in the drive cage. Each
HDD module can accommodate a SAS/SATA HDD with a maximum height
of 1 inch. The module is connected to the SAS/SATA backplane wirelessly.
This allows HDD/SSD modules to be plugged in and pulled out easily.
Optionally, you can also install a hard disk expansion box (Multibay 2, see
also section "Accessible drives / components" on page
3.5-inch SAS/SATA HDD modules). The HDD in this expansion box are
controlled by a SAS expansion card or by a second 8-Port RAID Controller.
– For up to sixteen 2.5-inch SAS/SATA HDD/SSD:
Up to sixteen SAS/SATA HDD/SSD modules can be used in the drive cage.
Each HDD/SSD module can accommodate an SAS/SATA HDD/SSD with a
2.5-inch format. The module is connected to the SAS/SATA backplane
wirelessly. This allows HDD/SSD modules to be plugged in or pulled out
easily.
Optionally, you can also install a hard disk expansion box (with up to eight
2.5-inch SAS/SATA HDD/SSD modules). An additional SAS controller must
be installed in order to control the hard disk drives in this expansion box. The
HDD in this expansion box are controlled by a SAS expandsion card or by a
second 8-Port RAID Controller.
I
Hybrid configurations of SAS and SATA HDD/SSD modules are not
supported.
Onboard SAS/SATA controller
A SAS/SATA controller is integrated on the system board; up to four SAS or
SATA hard disk drives can be connected to the controller. The LSI Embedded
MegaRAID software (Software RAID) supports RAID levels 0, 1 and 10. The
SAS functionallity needs to be enabled separately by using a ROM1 SCU Key.
For more information on configuring the controller, see section
onboard SAS/SATA controller" on page
TX300 S7 / RX350 S7
78.
Operating Manual
Functional overview
19) (with up to four
"Configuring the
17