Table of Contents
Advertisement
Adjusting the Tear-Off Position
F2 JAM SENS. Y (if 6 pin Front2 Push Tractor is installed)
or
F1 JAM SENS. Y (if 6 pin Front1 Push Tractor is installed)
or
MENU ENGLISH
↑
TEAR ADJUST: +30
TEAR ADJUST: ...
TEAR ADJUST: -390
↓
FUNCTIONS
TEAR ADJUST: xxx
See also "How to Use the Tear-Off Function", later in this Chapter.
→ or ←
→ or ←
→ or ←
These values adjust the distance between the Tear-Off Perforation and
the Tear-Off Bar. The values correspond to 1/180 inch units, i.e. the
tuning ranges between +1/6 and -13/6 inch. 0 is the default value.
70
Advertisement
Table of Contents
Need help?
Do you have a question about the 9070 plus and is the answer not in the manual?