Canon HV30 Instruction Manual page 89

Message
SET PRINT ORDER
READJUST TRIMMING
PRINTER ERROR
HARDWARE ERROR
COMMUNICATION
ERROR
CHECK PRINT SETTINGS The print setting cannot be used for printing with the
PRINTER IN USE
PAPER LEVER ERROR
PRINTER COVER OPEN
NO PRINTHEAD
No still image on the memory card has been marked with a print order.
You changed the print style after you set the trimming settings.
Cancel printing. Turn the printer off and then on again. Check the printer
status. If the error still persists, refer to the printer's instruction manual and
contact the appropriate customer support center or service center.
Cancel printing. Turn the printer off and then on again. Check the printer
status. If the printer is equipped with a battery, it might be exhausted. In
such case, turn off the printer, replace the battery and turn it back on.
The printer is experiencing a data transfer error. Cancel printing.
Disconnect the USB cable and turn off the camcorder and the printer. After
a short while, turn them on again, set the camcorder to
and restore the connection. When you are printing using the
check the print settings. Or, you attempted to print from a memory card that
contains a large number of images. Reduce the number of images.
The printer is in use. Check the printer status.
Paper lever error occurred. Adjust the paper selection lever to the proper
position.
Close the printer cover securely.
No print head is installed in the printer or the print head is defective.
Explanation/Solution
Trouble? 89
mode
button,
button.