Advertisement
3.4 MOUNTING OF GAS HOSE AND IMPERVIOUSNESS CONTROL
The gas of appliance must also be connected in accordance with standards. The
adjusted gas type of appliance must be determined on the type signboard on the
back of the appliance. You can find the information related to appropriate gas
types and appropriate gas injectors on technical data table. Pay attention that the
feeding gas pressure must be appropriate for the values on technical data table to
be able to get the most efficiency and to ensure the least consumption. If the
pressure of used gas is different than these values or changeable, it is required to
affix an available pressure regulator on the entrance pipe. It is surely required to
contact to the authorized service to make these adjusments.
The plastic hose that is fixed onto the gas entrance of appliance with a pipe collar,
must be used while connecting for Butane-Propane gas. Connect your appliance
with a short and impervious hose as much as possible to the gas resource. The
hose's permitted
appliance must be changed (1) once a year for your security.
The points that must be paid attention while connecting the hose;
No parts of the hose must not touch to any place that has heat more than
•
50 0 C.
The lenght of hose must not exceed 1.5m.
•
The hose must not be ruptured, be tightened or be folded.
•
The hose must not touch to the sharp corners, moving things, must not be
•
defective.
The hose must be controlled from end before mounting, it must be observed
•
whether there is any production defect.
As gas is turned on, all connection parts and hose must be controlled with
•
prepared much bubbly water at first after the gas entrance connections are
completely finished. Never use a lighter, match, etc. while making this
process.
The tightening pipe collars must clear of rust.
•
The use dates must not have exceeded over 5 years.
•
maximum lenght is 1.5m. The hose that brings gas to the
10
Hide quick links:
Advertisement
