Main Screen; Viewing Live Images And Controlling The Autodome Ptz - Bosch VG4 200 Series User Manual

44 en | Configuring and Using the IP AutoDome
8.6

Main Screen

By default, the IP AutoDome opens the LivePage window when started. The main screen is
divided into eleven segments as described in Table 8.1.
Figure 8.3 IP AutoDome Display Screen
Reference # Description
1
2
3
4
5
6
7
8
9
10
11
Table 8.1 IP AutoDome Overview
8.7

Viewing Live Images and Controlling the AutoDome PTZ

Once the network cables are properly connected and the IP AutoDome has a valid IP address,
you can view live images and control the PTZ controls over the TCP/IP network using
Microsoft Internet Explorer.
F01U073308 | 1.0 | 2007.09
The View-Control tab enables the user to control the camera (see Section
8.6.3).
The Aux Control tab is used to enter pre-programmed keyboard control commands.
The Camera 1 tab displays live video.
The Livepage enables the user to view live video.
The Recordings tab enables the user to view and manage recorded video. (This
tab becomes visible only after a recording device is selected on the Settings
page.)
The Settings tab enables the user to define General, Encoder, Camera,
Recording, Alarm, and Service settings.
The MPEG-4 Stream 1 tab enables the user to view compressed live video
which ensures the data remain low so that local conditions within wide limits
can be adapted.
The MPEG-4 Stream 2 tab enables the user to view live video.
The M-JPEG tab enables the user to view a JPEG picture compression in each
frame of video.
The System log display box contains information about the connection and operating status of the IP
AutoDome (see Section 8.6.4).
The Event log display box contains information about alarm connections (see Section 8.6.4).
VG4-200, VG4-300, VG4-500i Series User's Manual
AutoDome Modular Camera System
Bosch Security Systems, Inc.