Electrolux EFA90950 User Manual page 20

20 electrolux
Fixing the Frame
• Loosen the two screws fastening the
lower chimney and remove this from
the lower frame.
• Loosen the two screws fastening the
EN
upper chimney and remove this from
the upper frame.
If you wish to adjust the height of the
frame, proceed as follows:
• Unfasten the metric screws joining the
two columns, located at the sides of
the frame.
• Adjust the frame to the height required,
then replace all the screws removed as
above.
• Insert the upper chimney stack from
above, and leave it running free on the
frame.
• Lift up the frame, fit the frame slots
onto the screws up to the slot end
positions.
• Tighten the two screws and fasten
the other two screws provided with
the hood.
Before tightening the screws completely
it is possible to adjust the frame by
turning it. Make sure that the screws do
not come out of their seats in the slotted
holes.
• The frame mountings must be
secure to withstand the weight of
the hood and any stresses caused
by the occasional side thrust
applied to the device.
On completion, check that the
base is stable, even if the frame is
subjected to bending.
• In all cases where the ceiling is not
strong enough at the suspension
point, the installer must provide
strengthening using suitable plates
and backing pieces anchored to the
structurally sound parts.
INSTALLING THE COOKER HOOD
1
2
1
2