What To Do If - Electrolux EVY6600AO User Manual

Installing the shelf support
To install the shelf support follow the pro-
cedure in the opposite order.
11.2 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass cov-
er can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.

12. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
The appliance does not
heat up.
The appliance does not
heat up.
The appliance does not
heat up.
The appliance does not
heat up.
The appliance does not
heat up.
The lamp does not oper-
ate.
The display shows an er-
ror code that is not on
this list.
Problem
Replacing the lamp at the cavity
ceiling:
1.
2.
3.
4.
Possible cause
The appliance is deacti-
vated.
The clock is not set.
The necessary settings
are not set.
The automatic cut-out is
activated.
The fuse is released.
The lamp is defective.
There is an electrical fault. • Deactivate the appli-
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Turn the lamp glass cover counter-
clockwise to remove it.
Clean the glass cover.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
Install the glass cover.
Remedy
Activate the appliance.
Set the clock. Refer to
"Setting the clock".
Make sure that the set-
tings are correct.
Refer to "Automatic
switch-off".
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact
a qualified electrician.
Replace the lamp.
ance with the house
fuse or the safety
switch in the fuse box
and activate it again.
• If the display shows the
error code again, con-
tact the Customer Care
Department.
ENGLISH 21