Adjusting Bass; Adjusting Treble; Adjusting Loudness; Using Subwoofer Output - Pioneer DEH-P7400MP Operation Manual

Section
Audio Adjustments
08

Adjusting bass

You can adjust the cut-off frequency and the
bass level.
• In mode, bass adjustment affects only
FRT1
the rear output: front output cannot be
adjusted.
1 Press
AUDIO
Press until
AUDIO
2 Select the desired frequency with 2/3.
Press 2 or 3 until the desired frequency
appears in the display.
— — —
40 63 100 160
3 Press 5 or ∞ to adjust the bass level.
Each press of 5 or ∞ increases or decreases
the bass level.
+6
increased or decreased.

Adjusting treble

You can adjust the cut-off frequency and the
Treble level.
• In and
FRT1 FRT2
affects only the front output: rear output cannot
be adjusted.
1 Press
AUDIO
Press until
AUDIO
2 Select the desired frequency with 2/3.
Press 2 or 3 until the desired frequency
appears in the display.
— — —
2.5k 4k 6.3k
3 Press 5 or ∞ to adjust the treble level.
Each press of 5 or ∞ increases or decreases
the treble level.
+6
increased or decreased.
38
En
to select .
Bass
appears in the display.
Bass
(Hz)
– is displayed as the level is
–6
modes, treble adjustment
to select .
Treble
appears in the display.
Treble
(Hz)
10k
– is displayed as the level is
–6

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press to select
AUDIO
Press until
AUDIO Loud
2 Press 5 to turn loudness on.
Loudness level (e.g.,
Loud Mid
display.
3 Press 2 or 3 to select the level.
Press 2 or 3 until the desired level appears in
the display.
(low)— (mid)—
Low Mid
4 Press ∞ to turn loudness off.
appears in the display.
Loud OFF

Using subwoofer output

This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press to select
AUDIO
When the subwoofer controller setting is
, you cannot select
Control:EXT
until appears in the display.
AUDIO Sub-W1
2 Press 5 to turn subwoofer output on.
appears in the display.
Sub-W1 Normal
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
∞.
3 Press 2 or 3 to select the phase of sub-
woofer output.
Press 2 to select reverse phase and
appears in the display. Press 3 to select normal
phase and appears in the display.
Normal
.
Loud
appears in the display.
) appears in the
(high)
High
.
Sub-W1
S.W
. Press
Sub-W1
Rev.