Changing The Display Form; Adjusting The Brightness; Switching The Dimmer Setting; Selecting The Wall Paper Pattern - Pioneer DEH-P9400MP Operation Manual

Matching the time to a time signal
1. Press NEXT to display "CLK".
Press NEXT until "CLK" appears.
2. Press CLK and then press JUST to match
the time to a time signal.
• If the minute is "00" – "29", the minutes are
rounded down. (e.g., "10:18" becomes
"10:00".)
• If the minute is "30" – "59", the minutes are
rounded up. (e.g., "10:36" becomes
"11:00".)
Note:
• During date adjustment, "JUST" is not displayed.
C
hanging the display form
This product is equipped with two basic dis-
plays. You can select the desired display.
1. Press NEXT to display "C.MENU".
Press NEXT until "C.MENU" appears.
2. Press C.MENU and then press D.FORM to
select the display form mode.
3. Press either FORM1 or FORM2 to select
the desired display form.
A
djusting the brightness
Display brightness adjustment lets you adjust
the display for easier viewing when lighting con-
ditions change.
1. Press NEXT to display "C.MENU".
Press NEXT until "C.MENU" appears.
2. Press C.MENU and then press BRGHT to
select the brightness mode.
3. Press 2 2 or 3 3 to adjust the brightness.
Each press of 2 or 3 increases or decreas-
es the brightness.
• "00" – "31" is displayed as the brightness is
increased or decreased.
S
witching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed when
the car's headlights are turned on. You can
switch the dimmer on or off.
1. Press NEXT to display "C.MENU".
Press NEXT until "C.MENU" appears.
2. Press C.MENU and then press DMMER to
select the dimmer mode.
3. Press DMMER to turn the dimmer on.
"ON" appears on the display.
• Press DMMER again to turn the dimmer
off.
S
electing the wall paper pattern
The wall paper pattern is only for display form 2
"FORM2", and there are three patterns to
choose from.
• When you select "FORM1", "PTRN" is not dis-
played and this mode is inactive.
1. Press NEXT to display "C.MENU".
Press NEXT until "C.MENU" appears.
2. Press C.MENU and then press PTRN to
select the wall paper pattern mode.
3. Press any of the buttons A – C to select
the desired pattern.
S
etting the entertainment display
You can change the display to the movie
screens, the spectrum analyzer displays, etc.,
while listening to any source.
Setting the movie screen
There are four stored movie screens to select
from.
Continued overleaf.
58