Switching The Telephone Muting/Attenuation Setting; Setting The Fm Tuning Step; Setting The Warning Tone - Pioneer DEH-P9400MP Operation Manual

Initial Settings
S
witching the telephone
muting/attenuation setting
When a call is made or received using a cellular
phone connected to this product, the product
can be set to either mute or attenuate the audio
output.
1. With the source turned off, press and
hold 1.
2. Press MUTE.S to select the telephone
muting/attenuation mode.
3. Press MUTE.S to select the desired set-
ting.
Press MUTE.S repeatedly to switch between
the following settings:
TEL mute = 10dB ATT = 20dB ATT
Sound from this product is muted or attenu-
ated automatically when a call is made or
received using a connected cellular tele-
phone.
• "20dB ATT" has a stronger effect than
"10dB ATT", and "TEL mute" has a
stronger effect than "20dB ATT".
S
etting the FM tuning step
Normally, the FM tuning step is set at 50 kHz
during seek tuning, however, it changes to 100
kHz when the AF or TA function is on.
You can set the FM tuning step to 50 kHz even
when the AF or TA function is on.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press FMstep to
select the FM tuning step mode.
55
3. Press the corresponding button to select
the desired tuning step.
Button Tuning step
50K 50 kHz
100K 100 kHz
Note:
• The FM tuning step remains set at 50 kHz during
manual tuning.
• The tuning step returns to 100 kHz if the battery is
temporarily disconnected.
S
etting the warning tone
The warning tone sounds to remind you to
detach the front panel. (Refer to page 9.)
You can turn the warning tone function on or
off.
1. With the source turned off, press and
hold 1.
2. Press NEXT and then press DT-WRN to
select the warning tone mode.
3. Press DT-WRN to turn the warning tone
on.
"ON" appears in the display.
• Press DT-WRN again to turn the warning
tone off.