NAPCO Express XP-600 User Manual page 13

Keypad Beeps or Zone light
H ON
SYSTEM Flashes
2 Beeps 2
2 Beeps 3
2 Beeps 4
3 Beeps 1-6
4 Beeps 1-6
5 Beeps 1-4
6 Beeps 1-4
7 Beeps 1-6
System Trouble
Condition
Fire Trouble A problem has been detected in the Fire Circuit.
Call installing company for service.
Wireless A problem has been detected with the wireless receiver.
Receiver Trouble Call installing company for service.
Wireless A problem has been detected with a wireless receiver.
Receiver Jam Call installing company for service.
Wireless The battery in a wireless transmitter is low and should be replaced. This transmit-
Transmitter Low ter is on the zone corresponding to the number of the lit zone light. The replace-
Battery ment battery for the GEM-Trans2 door/window transmitter, GEM-PIR motion de-
tector and GEM-GB glass break detector is the Duracell DL123A. (2 required for
the GEM-PIR and GEM-GB.) The GEM-DT Dual Technology Sensor requires C-
Cell Duracell MN1400 batteries (4). Warning: Replace batteries only with the
same type as specified above. Use of another battery may present a risk of fire or
explosion. Do not recharge or disassemble battery, or dispose of in fire.
Wireless A problem has been detected with a wireless transmitter.
Transmitter Call installing company for service
Supervisory
Failure
Wireless Smoke The battery in a wireless smoke detector is low and should be replaced. This
Detector wireless smoke detector should be marked with a number corresponding to the
Low Battery number of the lit zone light. The replacement batteries required are Duracell 9
Volt Alkaline (2).
Warning: Replace batteries only with the same type as specified above. Use of
another battery may present a risk of fire or explosion. Do not recharge or disas-
semble battery, or dispose of in fire.
Wireless Smoke A problem has been detected with a wireless smoke detector.
Detector Supervi- Call installing company for service.
sory Failure
Zone Trouble Call installing company for service.
H System Troubles
Action
13