Setting The Tv - Sharp Aquos LC-32D44E Operation Manual

Quick guide

Setting the TV

Standard DIN45325 plug
(IEC 169-2)
75-ohm coaxial cable
Antenna
Connect the antenna cable from your antenna-
/cable socket or the (room-/roof) antenna for
antenna input terminal on the back of your TV set to
receive digitally/terrestrially broadcast stations.
An indoor antenna can also be used under good
reception conditions. Passive and active room
antennas are offered commercially. In an active
antenna its power is supplied via the antenna input
terminal.
The supply voltage (5V) must be correspondingly
set under "Supply Voltage". (See page 18.)
Bundling the cables
Bundle the cables
with the clamp.
Setting the TV on the wall
• This TV should be mounted on the wall only with the wall mount bracket available from SHARP. (See page 35.)
The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.
• The centre of the TV screen is 4 mm below "A" engraved onto the metal plate angle used for affixing to a wall.
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
• You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall.
4
Cable clamp
Place the TV close
to the AC outlet, and
keep the power plug
within reach.
Product shape varies
in some countries.
AC cord