Oldsmobile Silhouette Owner's Manual page 132

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with RSS
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation of
the device.
Changes or modifications to this system by other than an
authorized service facility could void authorization to
use this equipment.
-
PASS Key III uses a radio frequency transponder in the
key that matches a decoder in your vehicle.
-
When the PASS Key III system senses that someone is
using the wrong key, it shuts down the vehicle's starter
and fuel systems. The starter will not work and fuel will
stop being delivered to the engine. Anyone using a
- -
trial and error method to start the vehicle will be
discouraged because of the high number of electrical
key codes.
2-36
-
210 of Industry Canada.
When trying to start the vehicle if the engine does not
start and the PASS KEY light comes on, the key may
have a damaged transponder. Turn the ignition off and
try again.
If the engine still does not start, and the key appears to
be undamaged, try another ignition key. At this time,
you may also want to check the fuse (see "Fuses and
Circuit Breakers" in the Index). If the engine still does
not start with the other key, your vehicle needs service.
If your vehicle does start, the first key may be faulty.
See your dealer or a locksmith who can service the
-
PASS Key III to have a new key made.
It is possible for the PASS
transponder value of a new or replacement key. Up to
10 additional keys may be programmed for the vehicle.
This procedure is for learning additional keys only. If all
the currently programmed keys are lost or do not
operate, you must see your dealer or a locksmith who
-
can service PASS Key III to have keys made and
programmed to the system.
See your dealer or a locksmith who can service
-
PASS Key III to get a new key blank that is a cut
exactly as the ignition key that operates the system.
-
Key III decoder to learn the
yellowblue