Compliance Information; Declaration Of Conformity - Cisco RNG200 User Manual

FCC Compliance
United States FCC Compliance
This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
such interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment OFF and ON, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna, if applicable.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the service provider or an experienced radio/television
technician for help.
Any changes or modifi cations not expressly approved by Cisco
Systems, Inc., could void the user's authority to operate the
equipment.
The information shown in the FCC Declaration of Conformity
paragraph below is a requirement of the FCC and is intended to
supply you with information regarding the FCC approval of this
device. The phone numbers listed are for FCC-related questions
only and not intended for questions regarding the connection or
operation for this device. Please contact your service provider for
any questions you may have regarding the operation or installation
of this device.

Declaration of Conformity

This device complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions: 1) the device may not
cause harmful interference, and 2) the device must accept any
interference received, including interference that may cause
undesired operation.
Cisco RNG200 and RNG200N
High-Defi nition Digital-Only Set-Top
Model: RNG200 and RNG200N
Manufactured by: Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 770-236-1077
Canada EMI Regulation
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la class B est conforme à la norme
NMB-003 du Canada.
24
Software and Firmware Use
The software described in this document is protected by copyright
law and furnished to you under a license agreement. You may
only use or copy this software in accordance with the terms of
your license agreement.
The fi rmware in this equipment is protected by copyright law. You
may only use the fi rmware in the equipment in which it is provided.
Any reproduction or distribution of this fi rmware, or any portion of
it, without our express written consent is prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions
that may appear in this guide. We reserve the right to change
this guide at any time without notice.
AVC VIDEO LICENSE
With respect to each AVC/H.264 product, we are obligated to
provide the following notice:
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT
PORTFOLIO LICENSE FOR THE PERSONAL AND NON-
COMMERCIAL USE OF A CONSUMER TO (i) ENCODE VIDEO
IN COMPLIANCE WITH THE AVC STANDARD ("AVC VIDEO")
AND/OR (ii) DECODE AVC VIDEO THAT WAS ENCODED
BY A CONSUMER ENGAGED IN A PERSONAL AND NON-
COMMERCIAL ACTIVITY AND/OR WAS OBTAINED FROM
A VIDEO PROVIDER LICENSED TO PROVIDE AVC VIDEO.
NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY
OTHER USE. ADDITIONAL INFORMATION MAY BE OBTAINED
FROM MPEG LA, L.L.C. SEE HTTP://WWW.MPEGLA.COM.
Accordingly, please be advised that service providers, content
providers, and broadcasters are required to obtain a separate
use license from MPEG LA prior to any use of AVC/H.264
encoders and/or decoders.
20081121 FCC Standard