Service - Cub Cadet CC 550ES Operator's Manual

Service

Blade Care
WARNING:
sharpening or replacement, protect your hands with
a pair of heavy gloves or use a heavy rag to hold the
blade.
Periodically inspect the blade adapter for cracks, especially if you
strike a foreign object. Replace when necessary. Follow the steps
below for blade service.
1. Disconnect spark plug boot from spark plug. Turn mower
on its side making sure that the air filter and the carburetor
are facing up.
2. Remove the bolt and the blade bell support which hold the
blade and the blade adapter to the engine crankshaft. See
Figure 7-1.
Blade
Adapter
Blade Bell
Support
3. Remove blade and adapter from the crankshaft. See Figure
7-1.
4. Remove blade from the adapter for testing balance.
Balance the blade on a round shaft screwdriver to check.
Remove metal from the heavy side until it balances evenly.
When sharpening the blade, follow the original angle of
grind. Grind each cutting edge equally to keep the blade
balanced.
WARNING:
excessive vibration when rotating at high speeds. It
may cause damage to mower and could break
causing personal injury.
16
When removing the cutting blade for
Blade
Bolt
Figure 7-1
An unbalanced blade will cause
5. Lubricate the engine crankshaft and the inner surface of
the blade adapter with light oil. Slide the blade adapter
onto the engine crankshaft. Place the blade on the adapter
such that the side of the blade marked "Bottom" (or with
part number) faces the ground when the mower is in the
operating position. Make sure that the blade is aligned and
seated on the blade adapter flanges.
6. Place blade bell support on the blade. Align notches on the
blade bell support with small holes in blade.
7. Replace hex bolt and tighten hex bolt to torque: 450 in. lbs.
min., 600 in. lbs. max.
To ensure safe operation of your mower, periodically check the
blade bolt for correct torque.
Belt Care
1. Disconnect the spark plug wire and ground it against the
engine.
2. Drain the fuel tank or place a piece of plastic beneath the
cap to prevent gasoline leakage.
3. Tip mower on its side (air cleaner side of engine up).
4. Remove blade, adapter, and related hardware as instructed
under "Blade Care" above. See Figure 7-1.
a. Remove the self-tapping screws that secures the
engine baffle to the deck . See Figure 7-2. Remove
engine baffle.
Figure 7-2
b. Loosen self-tapping screw that secures deck baffle
to the deck. See Figure 7-2.
7
B
A