Table of Contents
Advertisement
SECTION 8: SERVICE
Tires
WARNING:
inflation pressure shown on the sidewall of the
tire.
The recommended operating tire pressure is
approximately 10 psi for the rear tires and 14 psi for the
front tires.
Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to
mow unevenly.
Fuse
A fuse is installed in your tractor's wiring harness to
protect the tractor's electrical system from damage
caused by excessive amperage.
If the electrical system does not function, or your
tractor's engine will not crank, first check to be certain
that the fuse has not blown.
It is located under the hood mounted behind the top of
the dash panel on the support bar.
Always use a fuse with the same
IMPORTANT:
amperage capacity for replacement.
WARNING:
inspecting, always disengage PTO, set
parking brake, stop engine and remove key to
prevent unintended starting.
Cutting Blades
WARNING:
remove ignition key and disconnect the spark
plug wire(s) before removing the cutting
blade(s) for sharpening or replacement.
Protect your hands by using heavy gloves
when grasping the blade.
WARNING:
adapter and/or spindle for cracks or damage,
especially if you strike a foreign object.
Replace immediately if damaged
The blades may be removed as follows.
•
Remove the deck from beneath the tractor, (refer to
Cutting Deck Removal on page 26) then gently flip the
deck over to expose its underside.
Never exceed the maximum
Before servicing, repairing, or
Be sure to shut the engine off,
Periodically inspect the blade
.
•
Place a block of wood between the center deck
housing baffle and the cutting blade to act as a
stabilizer. See Figure 19.
Hex Flange Nut
Spindle Assembly
•
Use a 15/16" wrench to remove the hex flange nut
that secures the blade to the spindle assembly. See
Figure 19.
To properly sharpen the cutting blades, remove equal
amounts of metal from both ends of the blades along
the cutting edges, parallel to the trailing edge, at a 25°
to 30° angle.
If the cutting edge of the blade has already
IMPORTANT:
been sharpened, or if any metal separation is present,
replace the blades with new ones.
It is important that each cutting blade edge be ground
equally to maintain proper blade balance. A poorly
balanced blade will cause excessive vibration and may
cause damage to the tractor and result in personal
injury.
The blade can be tested by balancing it on a round
shaft screwdriver. Grind metal from the heavy side until
it balances evenly.
When replacing the blade, be sure to
IMPORTANT:
install the blade with the side of the blade marked
''Bottom'' (or with a part number stamped in it) facing
the ground when the mower is in the operating position.
Use a torque wrench to tighten the blade
IMPORTANT:
spindle hex flange nut to between 70 lbs-ft and 90 lbs-ft.
25
Wood Block
Figure 19
Advertisement
Table of Contents
