Page 1
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 Printed In USA Form No. 769-07807...
Visit us on the web at www.cubcadet.com See How-to Maintenance and Parts Installation Videos at www.cubcadet.com/tutorials ◊ Locate your nearest Cub Cadet Dealer at (877) 282-8684 ◊ Write to Cub Cadet LLC • P.O. Box 361131 • Cleveland, OH • 44136-0019...
Important Safe Operation Practices WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
Page 4
A missing or damaged discharge cover can cause blade When starting engine, pull cord slowly until resistance contact or thrown object injuries. is felt, then pull rapidly. Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than Many injuries occur as a result of the mower being pulled you can let go.
Page 5
Service Check the blade and engine mounting bolts at frequent intervals for proper tightness. Also, visually inspect blade Safe Handling Of Gasoline: for damage (e.g., bent, cracked, worn) Replace blade with the original equipment manufacture’s (O.E.M.) blade only, To avoid personal injury or property damage use extreme listed in this manual.
Notice Regarding Emissions Spark Arrestor Engines which are certified to comply with California and federal WARNING: This machine is equipped with an EPA emission regulations for SORE (Small Off Road Equipment) internal combustion engine and should not be used are certified to operate on regular unleaded gasoline, and on or near any unimproved forest-covered, brush may include the following emission control systems: Engine covered or grass-covered land unless the engine’s...
Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate DANGER —...
Assembly & Set-Up Contents of Carton • One Lawn Mower • One Grass Catcher • One Grass Catcher Adapter • One Side Discharge Chute • One Engine Operator’s Manual • One Bottle of Oil • One Lawn Mower Operator’s Manual Assembly Remove hairpin clip from this hole.
Page 10
The rope guide, which is connected to the support rod, is Replace with grass bag adapter, while making sure the located on the right side of the lower handle. See Figure front lip of adapter goes under the edge of the deck. Refer 3-3.
Page 11
Adjustments Lift chute door on the grass bag adapter and slide grass bag onto the adapter. See Figure 3-6. Cutting Height The cutting height adjustment lever is located above the rear left wheel. See Figure 3-8A insert. Figure 3-6 Side Discharge Chute Follow steps below to install the side discharge chute: Figure 3-8 Remove mulching baffle or grass bag adapter from unit by...
Page 12
Set-Up Drive Control The adjustment wheel is located in the drive control handle Gas and Oil Fill-Up housing and is used to tighten or loosen the drive belt. You will have to adjust the drive control if any of the following happens: Refer to the separate engine owner’s manual for additional engine information.
Controls and Features Blade Control Drive Control Electric Start Ignition Switch Shift Lever Cutting Height Adjustment Lever Recoil Starter Side Discharge Chute Figure 4-1 Blade Control IMPORTANT: Move the shift lever only when the engine is running. Changing the shift lever setting with the engine off can The blade control is attached to the upper handle of the mower.
Operation Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.
Maintenance & Adjustments Maintenance Lubricate the wheels and casters at least once a season with light oil (or motor oil). If wheels are removed for any General Recommendations reason, lubricate the axle bolt and inner surface of the wheel with light oil. See Figure 6-1. •...
Page 16
Adjustments Engine Care A list of key engine maintenance jobs required for good Shift Lever Cable performance by the mower is given below. Follow the accompanying engine manual for a detailed list and instructions. Periodic adjustment of the six speed shift cable may be necessary due to normal wear on the cable.
To ensure safe operation of your mower, periodically check the blade bolt for correct torque. Belt Care NOTE: Several components must be removed in order to change the mower’s belt. See an authorized Cub Cadet Service Dealer to have your belt replaced. Replacing Battery Blade...
Charging Battery Remove the two screws securing battery cover to battery housing and place them to the side. See Figure 7-2. WARNING: The battery contains corrosive fluid Open battery cover, remove positive and negative leads and toxic material; handle with care and keep away from battery, remove and replace with new battery.
Page 19
Replacing Fuse Off-Season Storage The electric starter circuit and battery are protected by a 40 The following steps should be taken to prepare your lawn mower ampere fuse. If the fuse burns out, the electric starter will not for storage. operate.
Troubleshooting Problem Cause Remedy Engine Fails to start 1. Blade control disengaged. 1. Engage blade control. 2. Spark plug boot disconnected. 2. Connect wire to spark boot. 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4.
Page 21
Problem Cause Remedy Uneven cut 1. Wheels not positioned correctly. 1. Place all four wheels in same height position (if equipped with individual height adjusters). 2. Dull blade. 2. Sharpen or replace blade. Mower will not self propel 1. Belt not installed properly. 1.
Xtreme Mulching Blade Phone 877-282-8684 for your nearest Cub Cadet Dealer to order replacement parts or a complete Parts Manual (have your full model number and serial number ready). Parts Manual downloads are also available free of charge at www.cubcadet.com...
Page 23
490-850-0008 Oil Siphon Phone 877-282-8684 for your nearest Cub Cadet Dealer to order replacement parts or a complete Parts Manual (have your full model number and serial number ready). Parts Manual downloads are also available free of charge at www.cubcadet.com 9 —...
Refer to applicable manufactur- The limited warranty set forth below is given by Cub Cadet LLC with er’s warranty for terms and conditions. respect to new merchandise purchased or leased and used in the United b.