Maintenance & Adjustment - Troy-Bilt Bronco CRT Operation Manual

Maintenance & Adjustments
Maintenance Schedule
Check Motor Oil Level
Clean Engine
Check Drive Belt Tension
Check Nuts and Bolts
Lubricate Tiller
Check Gear Oil Level in Transmission
Check Tines for Wear
Check Air Pressure in Tires
WARNING!
Before inspecting, cleaning or servicing
the machine, shut off the engine, wait for all moving
parts to come to a complete stop, disconnect the
spark plug wire and move the wire away from the
spark plug. Failure to follow these instructions can
result in serious personal injury or property damage.
Maintenance
Engine
Refer to the Engine Operator's Manual packed with your tiller for
all engine maintenance.
Tire Pressure
Check the air pressure in both tires. The air pressure should be
between 15-20 PSI. Keep both tires equally inflated to help
prevent machine from pulling to one side.
Hardware
Check for loose or missing hardware after every 10 operating
hours and tighten or replace (as needed) before using tiller
Be sure to check the screws underneath the tiller hood that
secure the transmission cover and the Depth Regulator Lever to
the transmission.
Check After Before each
first 2 hours use
P
P
P
P
Lubrication
After every 10 operating hours, oil or grease the lubrication
points shown in Fig. 6-1 and described below.
Handlebar
Attaching Screws
Every Every
5 Hours 10 Hours 30 Hours
P
P
P
P
Depth
Regulator
Lever
Tine Shaft
Wheel Shaft
Figure 6-1
6
Every See Engine
Manual
P
P
P
P
15