Kuppersbusch ITE1370-1 User Manual
Kuppersbusch ITE1370-1 User Manual

Kuppersbusch ITE1370-1 User Manual

Hide thumbs Also See for ITE1370-1:

Advertisement

Quick Links

Gebruiks-
Notice
Benutzer-
User manual
aanwijzing
d'utilisation
information
Vriezer
Freezer
Congélateur
Gefriergerät
ITE1370-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ITE1370-1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Kuppersbusch ITE1370-1

  • Page 1 Gebruiks- Notice Benutzer- User manual aanwijzing d'utilisation information Vriezer Freezer Congélateur Gefriergerät ITE1370-1...
  • Page 2: Table Of Contents

    Contents Safety information Care and cleaning Control panel What to do if… First use Technical data Daily use Installation Helpful Hints and Tips Environmental concerns Subject to change without notice Safety information In the interest of your safety and to ensure ance.
  • Page 3 Warning! Any electrical component • Appliance's manufacturers storage rec- (power cord, plug, compressor) must ommendations should be strictly adhered be replaced by a certified service agent to. Refer to relevant instructions. or qualified service personnel to avoid • Do not place carbonated or fizzy drinks in hazard.
  • Page 4: Control Panel

    Service in either its refrigerant circuit or insula- tion materials. The appliance shall not • Any electrical work required to do the be discarded together with the urban servicing of the appliance should be car- refuse and rubbish. The insulation foam ried out by a qualified electrician or com- contains flammable gases: the appli- petent person.
  • Page 5: First Use

    This function stops automatically after 52 When the Alarm reset switch is pressed, hours. the warmest temperature reached in the It is possible to deactivate the function at compartment flashes on the Temperature any time by pressing the Fast freezing but- indicator .
  • Page 6: Helpful Hints And Tips

    Thawing Fill these trays with water, then put them in the freezer compartment. Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator Important! Do not use metallic instruments compartment or at room temperature, de- to remove the trays from the freezer. pending on the time available for this opera- Cold accumulators tion.
  • Page 7: What To Do If

    Important! Do not pull, move or damage means that there is no buildup of frost any pipes and/or cables inside the cabinet. when it is in operation, neither on the inter- Never use detergents, abrasive powders, nal walls nor on the foods. highly perfumed cleaning products or wax The absence of frost is due to the continu- polishes to clean the interior as this will...
  • Page 8: Technical Data

    Problem Possible cause Solution The compressor oper- The temperature is not set cor- Set a higher temperature. ates continually. rectly. The door is not closed correctly. Refer to "Closing the door". The door has been opened too Do not keep the door open longer frequently.
  • Page 9: Installation

    The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
  • Page 10 min. 200 cm min. 200 cm 3. Adjust the appliance in the niche. Installing the appliance Make sure that the distance between Caution! Make sure that the mains the appliance and the cupboard front- cable can move freely. edge is 44 mm. The lower hinge cover (in the accesso- Do the following steps: ries bag) makes sure that the distance...
  • Page 11 7. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). 5. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in op- posite case. 8. Install the part (Ha) on the inner side of the kitchen furniture.
  • Page 12: Environmental Concerns

    10. Open the appliance door and the kitch- en furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. 8 mm 13. Press the part (Hd) on the part (Hb). 11.
  • Page 13 help prevent potential negative about recycling of this product, please consequences for the environment and contact your local council, your household human health, which could otherwise be waste disposal service or the shop where caused by inappropriate waste handling of you purchased the product.
  • Page 14 222349473-A-092011...

Table of Contents