Panasonic TH-70LF50U Operating Instructions Manual page 26

Adjusting POS. /SIZE
H-POS Adjust the horizontal position.
H-SIZE Adjust the horizontal size.
CLOCK (During RGB and PC input signal)
PHASE Eliminate the À ickering and distortion.
DOT (During RGB and PC input signal)
CLOCK Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
adjust so that any such noise is minimized.
OVER Turn image over scan ON/OFF.
SCAN Con¿ gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)
ON
Notes:
• "OFF" is effective during only "FULL" aspect mode.
• When "OFF" is set, "H-SIZE" and "V-SIZE" cannot be adjusted.
1:1 PIXEL Adjusts the display size when 1125i or 1125p signal is input.
MODE
Notes:
• "ON" is effective during only "FULL" aspect mode.
• Select ON when you would like to replay 1920 × 1080 input signal.
• Applicable input signal;
1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p
• Select OFF when À ickering is shown around the image.
• H-SIZE and V-SIZE cannot be adjusted when ON is selected.
OFF
Helpful Hint (
While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION
( ) button is pressed during "NORMALIZE", then all adjustment values (except "CLOCK PHASE" and "DOT CLOCK")
are returned to the factory settings.
26
OFF
ON
/ Normalization)
NORMALIZE
V-POS Adjust the vertical position.
V-SIZE Adjust the vertical size.