Table of Contents
Advertisement
To select the subwoofer cutoff frequency
—
WooferFreq (only for KD-LX333)
When a subwoofer is connected to this unit, select
an appropriate cutoff frequency level for your
subwoofer. When shipped from the factory, the
subwoofer cutoff frequency is set to "FREQ MID."
• FREQ LOW:
Frequencies higher than
50 Hz are cut off to the
subwoofer.
• FREQ MID:
Frequencies higher than
80 Hz are cut off to the
subwoofer.
• FREQ HIGH:
Frequencies higher than
120 Hz are cut off to the
subwoofer.
To change the AM/FM channel intervals
—
AREA
When this unit is shipped from the factory, the
channel intervals are set to 10 kHz for AM and
200 kHz for FM (AREA US settings).
You will have to change the channel intervals
when using this unit in an area other than North
America and South America.
• AREA EU:
Select this when using this unit
in an area other than North and
South America.
(9 kHz for AM and 50 kHz (for
manual tuning) / 100 kHz (for
searching) for FM)
• AREA US:
Select this when using this unit
in North or South America.
(10 kHz for AM and 200 kHz for
FM)
Note:
If the channel intervals settings are changed, the
following will occur.
• The names assigned to the stations will be erased
from memory. To reassign the names, see
"Assigning names to the sources" on pages
23 and 24.
To adjust the line input level —
(only for KD-LX333)
Adjust the line input level properly when an
external component is connected to the LINE
INPUT plugs. When shipped from the factory, the
line input level is set at level "00."
If the input level of the connected component is
not high enough, increase the input level properly.
Without adjusting the line input level, you may be
surprised at a loud sound when you change from
the external component to another source.
To select the external component to use
––
EXT INPUT (only for KD-LX111)
You can connect the external component to the
CD changer jack on the rear using the Line Input
Adaptor KS-U57 (not supplied).
To use the external component as the playback
source through this unit, you need to select which
component – CD changer or external component
– to use. When shipped from the factory, CD
changer is selected as the external component.
• LINE INPUT:
To use the external component
other than CD changer.
• CD CHANGER:To use the CD changer.
Note:
For connecting the Line Input Adaptor KS-U57 and
the external component, refer to the Installation/
Connection Manual (separate volume).
To make the front panel look flat (hiding
the control panel) —
When operating the receiver using the remote
control, you can hide the control panel to make
the front panel look flat. When shipped from the
factory, "FLAT OFF" is selected.
• FLAT ON:
The control panel will not come
out when you turn on the unit.
To use the control panel, press
4
panel comes out. If no
operation is done for about 10
seconds, it automatically goes
back into the receiver.
• FLAT OFF:
You can use the control panel
normally.
Note:
When "FLAT ON" is selected, you can eject a CD by
holding 4
.
LINE ADJ
FLAT PANEL
so that the control
21
Hide quick links:
Advertisement
Table of Contents
