JETWAY V6FP User Manual page 15

(2) PS/2 Mouse & PS/2 Keyboard Connector: KB/MS
The connectors for PS/2 keyboard and PS/2 Mouse.
(3) USB Port connector: USB
The connectors are 4-pin connector that connect USB devices to the system board.
(4) LAN Port connector: LAN (only for V6FP)
This connector is standard RJ45 connector for Network.
(5) Parallel Port Connector (25-pin female): PARALL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-board
Parallel Port can be disabled through the BIOS SETUP.
"INTEGRATED PERIPHERALS SETUP" section for more detail information.
Audio and Game Connector : AUD _ GAME
(6)
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin
D-Subminiature Receptacle Connector for joystick/MIDI Device.
Line-out :
Line-in :
MIC :
Game/MIDI :
(7) Serial Port COM1 : COM1
COM1, COM2 are the 9-pin D-Subminiature mail connector. The On-board serial port can
be disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED
PERIPHERALS SETUP" section for more detail information.
(8) VGA Connector (15-pin D-Sub) Connector: VGA
VGA is the 15-pin D-Subminiature female connector for display monitor.
(9) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
Pin 1
Audio output to speaker
Audio input to sound chip
Microphone Connector
For joystick or MIDI Device
PS/2
LAN
Mouse
PS/2
USB
Keyboard
PIN ROW2
1 3.3V
2 -12V
3 GND
4 Soft Power On
5 GND
6 GND
7 GND
8 -5V
9 +5V
10 +5V
PRINT GAME/MIDI PORT
COM1 VGA
12
ROW1
3.3V
3.3V
GND
5V
GND
5V
GND
Power OK
+5V (for Soft Logic)
+12V
Please refer to Chapter 3
MIC
LINE-IN
LINE-OUT