Leveling - Viking VCFF236 Installation Manual

Installation
Connect to Water Line
(cont.)
6. Fasten the shutoff valve to the cold water pipe 5. Using an adjustable wrench, hold the nut on
with the pipe clamp. Be sure the outlet end is
solidly in the 1/4" drilled hole in the water pipe
and that the washer is under the pipe clamp.
Tighten the packing nut. Tighten the pipe
clamp screws slowly and evenly so washer
makes a watertight seal. DO NOT overtighten
or you may crush the copper tubing.
7. Slip the compression sleeve and compression
nut on the copper tubing as shown. Insert the
end of the tubing into the outlet end squarely
as far as it will go. Screw compression nut onto
outlet end with adjustable wrench. DO NOT
overtighten.
8. Place the free end of the tubing in a container
or sink, and turn ON the main water supply.
Flush the tubing until water is clear. Turn OFF
the shutoff valve on the water pipe.
Connect to Refrigerator
6. Check connection by pulling on copper tubing.
1. Create a service loop (minimum diameter of 2
ft. [61.0 cm]) with the copper tubing. Avoid
kinks when coiling the copper tubing.
2. Remove the plastic cap from water valve inlet
port. Place a compression nut and sleeve on
the copper tubing.
3. Insert the end of the copper tubing into the
water valve inlet port. Shape tubing slightly so
that the tubing feeds straight into the port to
avoid kinks.
4. Slide the compression nut over the sleeve and
screw into the water valve inlet port.
A
B
C
D
A. Plastic water tubing C. Compression nut
B. Sleeve D. Copper tubing
16
the plastic water line to keep it from moving.
Then, with a second wrench, turn the
compression nut on the copper tubing
counterclockwise to completely tighten.
DO NOT overtighten.
A
B
C
D
E
A. "P" clamp C. Compression nut
B. Plastic water line D. Copper tubing
Attach copper tubing to refrigerator cabinet
with a "P" clamp. Turn on water supply to
refrigerator and check for leaks. Correct any
leaks.
Leveling/Adjusting the Door
To enhance the appearance and maintain performance, the refrigerator should be level.
To protect property and refrigerator from damage, observe the following:
• Protect vinyl or other flooring with cardboard, rugs, or other protective material.
DO NOT
• use power tools when performing leveling procedure.
Materials Needed
• 1/4" hex head driver
• Carpenter's level
Note: Complete any required panel installation and/or water supply connection before leveling.
Refrigerator should be in permanent location prior to leveling.
1
To raise the front of the refrigerator, turn the leveler foot
Remove toe grille. Grasp firmly and pull outward
to unclip. screw clockwise. Note: Having someone push against the
top of the refrigerator takes some weight off the leveler
3
To lower the front of the refrigerator, turn the leveler foot
screw counterclockwise. Note: Having someone push
against the top of the refrigerator takes some weight off
the leveler foot. This makes it easier to turn the levelers.
It may take several turns of the leveler foot screw to
adjust the tilt of the refrigerator.
17
2
foot screws.
4
Replace toe grill. Align the toe grille mounting clips
with the lower cabinet slots. Push the toe grille firmly
until it snaps into place. Check for level.