Water Supply Requirements; Remove And Replace Handles; Remove Doors And Hinge - Viking VCFF236 Installation Manual

General Information

Water Supply Requirements

A cold water supply with water pressure of
between 35 and 120 psi (241 and 827 kPa) is
required to operate the water dispenser and ice
maker. If you have questions about your water
pressure, call a licensed, qualified plumber.
Reverse Osmosis Water Supply
IMPORTANT: The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to
be between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa).
If the water pressure to the reverse osmosis
system is less than 40 to 60 psi (276 to 414 kPa):
• Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace the
filter if necessary.
• Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
• If your refrigerator has a water filter, it may
further reduce the water pressure when used in
conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualified plumber.
12
Doors & Drawer Removal

Remove and Replace Handles

Remove Doors and Hinges
1. Using a 3/32"or 1/8" hex wrench, loosen the 6. Remove the parts for the top hinge as shown in
two set screws located on the side of each
handle.
2. Pull the handle straight out from the door.
Make sure you keep the screws for reattaching
the handles.
3. To replace the handles, reverse the directions.
Remove Doors and Hinges
IMPORTANT: Remove food and any adjustable
door or utility bins from doors.
TOOLS NEEDED: 5/16", 3/8", 1/4" hex-head
socket wrench, #2 Phillips screwdriver, and a flat-
blade screwdriver.
1. Unplug refrigerator or disconnect power.
2. Keep the refrigerator doors closed until you are
ready to lift them free from the cabinet.
Note: Provide additional support for the
refrigerator door while the hinges are being
removed. DO NOT depend on the door gasket
magnets to hold the door in place while you
are working.
3. Starting with the right-hand side door, remove
the parts for the top hinge as shown in Top
Hinge graphic. Lift the refrigerator door from
the bottom hinge pin.
Note: Remove the hinge pin cover from the
bottom hinge pin and keep for later use. See
Bottom Hinge graphic.
4. Before removing the left-hand side door,
disconnect the wiring plug located on the top
of the top hinge by wedging a flat-blade
screwdriver or fingernail between the two
sections. See Wiring Plug graphic.
13
(cont.)
Top Hinge graphic. Lift the left-hand side door
from the bottom hinge pin.
Note: Remove the hinge pin cover from the
bottom hinge pin and keep it for later use. See
Bottom Hinge graphic.
Top Hinges
A
B
C
D
A. Hinge Cover Screw
B. Top Hinge Cover
5 /
C. " Hex-Head Hinge Screws
16
D. Top Hinge
Bottom Hinges
A
B
C
A. Hinge Pin Cover
B. Bottom Hinge
C. Hinge Screws
Wiring Plug